We anodize in Black, and Clear.
Standard Ball screws are 20mm X 5mm pitch with a C7 tolerance. .1mm over 300mm
Premium Ball screws are 20mm X 5mm pitch with a C6 tolerance. 23 microns over 300mm
We haven't taken any fancy pictures as of yet. We do have the pictures from building and fitting this. It is our best yet.
I'm sure you will like it as much as we do.
PM-30MV W/DOUBLE BALL NUT $949.00 buy here
PM-30MV W/premium ball screws AND DOUBLE BALL NUTS $1149.00 buy here
This kit includes:
3 ball screws. 20mm X 5mm pitch
3 ball nuts. Preloaded for minimal backlash.
X axis motor mount for Nema 34 motor
X axis ball nut block and bearing block
Y motor mount for Nema 34 motor
Y axis ball nut block
Z motor mount for Nema 34 motor
Z axis ball nut block & bearing block
Zero backlash helical couplings for X, Y & Z axis
Stainless steel cap screws for mounting motors, and other hardware as needed
New Thrust bearing for all 3 axis'
All 6061 aluminum parts anodized to be scratch and corrosion resistant.
Machine will need modifications to fit ball nut for X axis.
The table will need to have about .1" removed from the bottom side
Pictures and dimensions shown in instructions

Installation
Installation instruction for the PM-30MV